Salamander-designs CL/WK1 Uživatelský manuál stáhnout pdf

WALL MOUNT

CHAMELEON

TOOLS REQUIRED

1. Remove top and feet. Install provided connector bolt in previous foot locations.

2. MARK WALL LOCATION

A. WOOD CONSTRUCTION - Using a stud finder, mark the locations of

the studs in the area to be covered by the cabinet. It may be necessary to shift the cabinet

slightly left or right to avoid the mounting brackets being obstructed by the vertical

framework of the cabinet.

Note: It is not important that the brackets are not located in the same relative location in

each bay. As long as a bracket is located every 16” on center sufficient capacity will be met.

B. MASONRY CONSTRUCTION - Mark the wall 2” inward from each

side panel and 2” left or right of each divider panel.

2”

Pencil

Tap Measure

Connector Bolt

(300-540)

Plastic Wall

Plug

Bracket

(303-850)

Lag ScrewWasher

6 mm Hex Key

Leveling Set Screw

(300-540)

Stud Finder

Drill and Bit:

3/16” (5 mm) for Wood

3/8” (10 mm) for Masonry

Level

COMES WITH

BEFORE YOU BEGIN

• This bracket is intended for use with Chameleon 20” Tall Cabinets.

• Total weight capacity of each bracket is: 100 lbs. (45kg). (ex 3 brackets provides

300 lbs. (135kg).

• Carefully inspect your items for shipping damage or missing parts. If any damage is apparent or you are

missing parts contact Salamander Designs Ltd. at 800-535-5659.

• Read ALL assembly instructions before assembly. If you have any questions, please contact your installation

contractor or Salamander Designs.

• Use with products heavier than the maximum weight or other than the cabinet indicated may result

in instability causing possible injury or damage.

• Mounts must be attached as specified in assembly instructions. Improper installation can result in

serious personal injury.

3/16” Hex Key (400-060)

1/8” Hex Key (400-070)

CAPACITIES (CONTENT)

SINGLE: 100lbs

TWIN: 100lbs

TRIPLE: 200lbs

QUAD: 250lbs

1 2

WALL MOUNT 1

Shrnutí obsahu

Strany 1 - WALL MOUNT

WALL MOUNTCHAMELEONTOOLS REQUIRED1. Remove top and feet. Install provided connector bolt in previous foot locations. 2. MARK WALL LOCATIONA. WOOD CON

Strany 2

3. MARK HEIGHT LOCATIONMove the cabinet from the mounting location. Determine the desired height of the top of the cabinet (28” (711mm) is common). Fr

Komentáře k této Příručce

Žádné komentáře

Salamander-designs CL/WK1 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro TV příslušenství Salamander-designs CL/WK1. Salamander Designs CL/WK1 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro TV příslušenství Salamander-designs CL/WK1